Dollar Tree Bubble-Wand Microphone 6mm/10mm/15mm Sci-Fi Building

Chris Palmer While on my trip to get the new Dollar Tree “Tombstone Corner” Halloween Scenery (See my previous post), I also noticed these microphone shaped bubble-wands in the toy aisle.  I thought the tops had good possibility to be converted into some sort of sci-fi building for my upcoming 10mm sci-fi project.  Perhaps storage tanks, or a communications center of some kind

Shown with a U.S. Quarter for scale.

The tops unscrew easily, and the attached wand was easily pulled from its mounting inside the cap. I then gave the tops a scrub with soapy water (using the bubble fluid inside the handles! 🙂  )  I started to try to remove the sticker label on the tops; but as is so often the case with these labels, it tore apart into little bits rather than come off easily.  So, I decided that the labels were centered enough on the side panels to probably not be too noticeable after painting.  I cleaned up the one panel where I had tried to remove the label, and left the rest in place.

I then cleaned up the molding seams as best I could and glued the microphone tops to cut-down old hotel key-cards.  I then cut out some simple doors from thin cardboard and glued those on.   Finally I added  little plastic toy bit to each piece for visual interest.  After the glue dried, I painted the buildings with flat black spray paint.

 When the spray paint was dry, I painted the buildings with a simple tan color scheme, then gave them a brown ink wash, and finished with a light drybrushing to bring out the surface texture on the “domes”.  Next, I glued sand to the bases and painted it with a series of drybrushings.

I’m really pleased with how these turned out.  They are shown in the photo above with some 10mm Mechwarrior figures for scale.

via One More Gaming Project
from Tumblr

Author: hawksgameclub

Leave a Reply

Your email address will not be published. Required fields are marked *