Assembling and De-Necro-ing the Stygian Barge: Bones 4 Model

Chris Palmer

     Welcome to a special Thursday blog post!   I was excited to get the Stygian Barge Add-On from the recent Bones 4 Kickstarter, and I was not disappointed in the model when it arrived.  It is a truly beautiful and big ship.

      However, I didn’t necessarily want to use the barge in all its Stygian glory; it looked more like a Necromancer’s fancy yacht than anything else.  I wanted more of a plain everyday working barge.  I figured a plain barge would have much more game use than one specifically decked out in death-related motifs.  So, the first thing I set about doing was looking over the pieces to see just what removing all the skulls, etc. would involve.  With a little effort it seems like it just might work

All the Barge pieces minus the figurehead pieces and the crew and passengers.

      The first thing I did was to glue the front middle and rear hull sections together using Gorilla Superglue Gel.  I then used coffee stirrers and toothpicks to lay down a new deck and trim in the middle hull section to cover over the bone strewn deck that is molded onto the model. 

    I then cut off the two skull decorations on the front protrusions of the rear deck piece, and replaced them with two round wood beads.  When they were dry, I glued the rear deck and front deck into place.  I then painted the hold interior on the front deck with Ceramcoat “Black”.

When the Black was dry I glued the hold cover over it, and then worked on putting together the rope and anchor assembly.  I then glued the barrel assembly to the other side

      After that, I worked on gluing in the rear deck bracers.

    I then began trimming the vertebrate spines off of the rear deck roof, and trimming the skeletons off of the roof supports.

     Next, I glued the rudder into place, and then the mast.  I left the skull on the mast, figuring it looked like some kind of trophy or oddity the crew came across, rather than strictly saying “necromancer’s boat”. 
     When these ware dry, I glued the roof supports to the deck, setting the roof in place to keep them aligned while the glue set, but not actually gluing the roof.  I don’t want to permanently glue the roof until after I have painted the underside.

      After the roof supports were dry, I worked on fixing where the skeletal mermaid figurehead was supposed to go.  I used a bit of bamboo skewer to make a spar, and a little nail in the center of the rope circle to make it look like it was actually hanging from something.

      Lastly, I cut the skulls off of the ends of the railings, and once de-skulled, glued them into place

   And here is the finished boat; ready for painting!   I’m very pleased with how it turned out, and think it will look suitably like a regular workaday barge.  Hopefully I will get it painted in time to use it in our June Ghost Archipelago game.

via All Bones About It http://allbonesabout.blogspot.com/2019/05/assembling-and-de-necro-ing-stygian.html
from Tumblr https://harfordhawks.tumblr.com/post/184758841108
via IFTTT